Skip to main content
Firmware 4.2.x

Driver permanents

Due to less resources available in the esc3 and esc4 family of the controllers, some of the permanents are only present in esc5 family.

Permanents​

single_run/maxcurrent [A]​

The maximal measured battery current during the current run of the controller.

single_run/maxvoltage [A]​

The maximal measured battery voltage during the current run of the controller.

single_run/maxtemp [°C]​

The maximal measured controller temperature during the current run of the controller.

single_run/mintemp [°C]​

The minimal measured controller temperature during the current run of the controller.

single_run/minmotortemp [ohm]​

The minimal measured motor temperature sensor resistance during current run of the controller.

Can be reset by an user with rights level greater or equal to 2

single_run/maxmotortemp [ohm]​

The maximal measured motor temperature sensor resistance during current run of the controller.

Can be reset by an user with rights level greater or equal to 2

single_run/maxerpm [1/min]​

The maximal measured motor speed during current run of the controller.

single_run/enegy [J]​

The accumulated absolute value of the energy that went trough the controller during the current run. Regeneration will also increase the energy.

single_run/cap [mAh]​

The accumulated capacity that went trough the controller during the current run. Regeneration will decrease the capacity.

total/maxcurrent [A]​

The maximal measured battery current during the controller's lifetime.

total/maxvoltage [A]​

The maximal measured battery voltage during the controller's lifetime.

total/maxtemp [°C]​

The maximal measured controller temperature during the controller's lifetime.

total/mintemp [°C]​

The minimal measured controller temperature during the controller's lifetime.

total/minmotortemp [ohm]​

The minimal motor temperature sensor resistance during the controller's lifetime.

Can be reset by user with rights level greater or equal to 2

total/maxmotortemp [ohm]​

The maximal measured motor temperature sensor resistance during the controller's lifetime.

Can be reset by an user with rights level greater or equal to 2

total/enegy [J]​

The accumulated absolute value of the energy that went trough controller during the controller's lifetime. Regeneration will also increase the energy.

err_counter [-]​

Number of the errors (driver/error), that occured on the controller.

The following error codes are not counted:

  • Low voltage, caused by regular controller shutdown
  • Service errors (identrun, reinit,...)